Start with the symptom
| What you notice | Likely cause | Try first |
|---|---|---|
| Water drains slowly | Hair and soap in the drain | Remove the stopper, clear by hand |
| Spout drips when off | Worn cartridge or washer | Replace the cartridge |
| Water comes from the spout when the shower is on | Worn diverter | Replace the diverter |
| Handle is loose or leaks | Worn seals or cartridge | Replace the cartridge or seals |
| Stain on the ceiling below | Leak in the drain, overflow or valve | Shut off water, call a plumber |
| Tub fills slowly | Debris in the cartridge or a failing valve | Clean or replace the cartridge |
A slow tub drain
Most slow tub drains come from hair and soap near the stopper. Remove the stopper or the strainer and pull out what you find. A plastic drain-cleaning strip that grips hair works better than a liquid cleaner.
If the tub is still slow, the clog is deeper. A snake or a plumber is the next step. If several fixtures drain slowly, the problem may be the main line, and our drain cleaning page explains the options.
A dripping spout or loose handle
Most modern tub and shower valves use a cartridge. A drip means the cartridge or its seals are worn. Replacing the cartridge is usually a short job if the plumber has the right part for your brand.
Before you try it yourself, shut off the water to the bath or the whole house. If you cannot tell which brand you have, a plumber can identify it from the handle and trim.
Water through the ceiling below the bath? Call now.
Call (732) 466-1098Leaks you cannot see
A tub can leak from its drain, its overflow, the supply lines or the valve body inside the wall. A stain on the ceiling below or a soft spot in the floor is the usual sign. Water pooling in a basement under the bath is another.
Shut off the water to the bath and call. A plumber uses a moisture meter and sometimes a camera to find the source. Our leak detection page describes the tools. Do not wait, because a slow leak rots framing and breeds mold.
When the valve will not shut off
If the handle spins without stopping the water, the cartridge has failed or the valve body is damaged. Close the main water valve to stop the flow and call for same-day help.
Valves behind tile may need an access panel. A plumber can often replace the cartridge from the front without opening the wall, but a corroded valve body needs access.
Diverters and tub spouts
Many tub spouts have a pull-up diverter that sends water to the shower. When the diverter wears, water leaks from the spout while the shower runs and the shower pressure drops. Some spouts unscrew by hand, and others have a small set screw under the spout. Replacing the whole spout is often easier than repairing the diverter.
Measure the pipe that sticks out of the wall before you buy a replacement, since slip-on and threaded spouts differ. Seal around the spout with silicone so water cannot get behind the wall.
Caulk and grout
A cracked caulk line between the tub and the wall lets water reach the framing behind it. Scrape out the old bead, dry the joint fully and apply a new bead of a bath-rated caulk. A small crack that is fixed early can save a wall. Soft or stained tile near the tub can mean water has already been getting behind it.
Middletown local note
Middletown's water comes from New Jersey American Water's Coastal North system, where 2023 total hardness ran 72 to 140 ppm. Moderately hard water leaves scale in tub cartridges and diverters, which can cause stiff handles and drips over time.
New Jersey requires licensed master plumbers for plumbing work, and the Middletown construction office at 1 Kings Highway, 732-615-2106, can tell you when a bath remodel needs a permit. Homes near Red Bank are covered by our Red Bank page.
Plumbing standards in New Jersey come from the National Standard Plumbing Code 2021, adopted at N.J.A.C. 5:23-3.15, and the licensed master plumber you hire is responsible for meeting them.
Prevent tub problems
Clean the stopper monthly. Replace caulk when it cracks, since water that gets behind a tub rots the wall. Operate the valve gently, because a handle forced past its stop wears the cartridge.
Questions we hear from Middletown homeowners
Many people can, with the right cartridge and a wrench. Shut off the water first. If the valve is corroded or the part is unclear, a plumber is safer.
A worn cartridge or seals inside the valve is the usual cause. Replacing the cartridge stops it.
A stain below the bath, a soft floor or a wet wall point to a hidden leak. Shut off the water and call a plumber.
Older tubs may have corroded drains and valves. A plumber can replace the drain assembly and cartridge without replacing the tub in many cases.

